Whole-home duct cleaning
Dryer vent cleaning
Camera inspection
Sanitizing & deodorizingWhole-system duct and dryer vent check with before-and-after photos - you see exactly what came out of your vents
That "$99 whole-house special" is a bait ad - the real number appears once they are in your hallway, or the "clean" is a shop-vac at the register. We photograph the inside of your ducts before and after instead.
Fast, Reliable Duct Repair & Sealing Across Fordham
If your Fordham apartment or building is leaking air, pushing dust from the registers, or losing heat on the top floor, the ductwork behind the walls is usually the reason. We repair and seal duct systems in Fordham’s walk-ups and co-ops, and we do it with remediation-grade equipment: Rotobrush contact cleaning, Nikro HEPA source removal, and Abatement Technologies air scrubbing running while we work. Call (844) 702-0856 for a free estimate. We answer 24/7, with fast dispatch from 7am to 7pm, Sunday through Friday.

Our technicians have up to 9 years of experience, and they know what Fordham’s older buildings throw at them. The work we do on the Grand Concourse and around Fordham Road is not the same job as a suburban ranch house. It’s tighter, older, and shared between neighbors.
Why Fordham Homeowners and Supers Call Air Duct Cleaning Bedford Park for Duct Repair & Sealing
Most of the duct problems we see in Fordham are not new failures. They’re seventy- and eighty-year-old decisions that finally gave out: a trunk joint that separated after decades of heating cycles, a flex run crushed behind drywall during a renovation, a seal that peeled off soot-loaded galvanized steel within a season. We start by finding out what’s actually happening inside the system, not by quoting a repair blind. A camera inspection tells us where a run is pinched, disconnected, or leaking into a wall cavity, and that’s what we base the estimate on.
We serve Fordham regularly, and the buildings here have a particular set of problems. That’s why our duct repair & sealing team treats surface prep as a real step rather than a formality. Supers and co-op boards here want documentation, and we understand that. Before-and-after photos are part of the job, because a tenant complaint or a board question is easier to answer with pictures of what was actually sealed. One flat price per system gets agreed before any work starts, so there are no surprises once we’re on site.
Styles & brands we work with
- Whole-home duct cleaning
- Dryer vent cleaning
- Camera inspection
- Sanitizing & deodorizing
Our Duct Repair & Sealing Services in Fordham
We cover the full chain: cleaning, sanitizing, duct repair and sealing, and air quality systems from Honeywell and Aprilaire. When ductwork is failing, sealing is often the fix that actually changes what you feel in the apartment.
Duct Sealing in Fordham
Sealing is the highest-value repair in most Fordham buildings. Original galvanized trunk joints in these 1920s-1940s walk-ups separate after decades of expanding and contracting with the heat, and the gaps leak soot-laden air straight into wall cavities. We clean the joint surface first, then seal it so it holds. Skip that prep and the seal fails.

Metal Duct Repair in Fordham
The original steel ductwork in Fordham is heavy, rectangular, and worth saving. Repairing it beats replacing it: we rejoin separated trunk sections, patch holes and corrosion points, and re-support runs that have sagged or pulled loose. In a five- or six-story building, that repair is often the difference between an even heat across the apartments and a cold top floor.

Mastic Sealant in Fordham
Mastic is the right material for galvanized steel, but only on a clean surface. Coal-era soot coats a lot of these ducts even decades after the conversion, and mastic applied over soot peels within a season. We scrub the surface down and let it dry before applying. That extra step is why the seal still holds next winter.

Flex Duct Repair in Fordham
Flex runs added during apartment renovations are a common weak point. Drywall goes up, the run gets pinched or disconnected behind it, and the register on the floor above starts starving for air. We find these with a camera, then reconnect, reroute, or replace the run without tearing apart more wall than necessary. Where a whole run is unsalvageable, we’ll tell you so honestly and quote the fix.
Trusted Brands We Service in Fordham
Our work assumes the equipment most residential competitors never carry: Rotobrush for contact cleaning of the duct walls, Nikro for HEPA source removal at the point of disturbance, and Abatement Technologies air filtration running throughout the job so dislodged dust gets captured, not redistributed into your apartment. We also work with Honeywell and Aprilaire air quality products and know how they integrate with the existing system. Guardsman products come up too when a system needs it. Ask us what equipment we’re bringing before we arrive, and we’ll tell you exactly.
Common Duct Repair & Sealing Problems We See in Fordham Homes
- Trunk joints that pulled apart after the coal-to-gas conversion. Original ductwork engineered for gravity coal heat was often undersized for the forced-air systems that replaced it, and a prior conversion can leave the trunk pinched behind a wall. The gap leaks heated air into the cavity, which is why upper floors stay cold and the boiler runs harder than it should.
- Flex runs crushed behind new drywall. Apartment renovations are constant in Fordham’s walk-ups, and each one can pinch or disconnect a flex run. The register above still blows, just not enough, and it’s easy to blame the system rather than the duct.
- Mastic and tape letting go on soot-coated steel. Coal-era soot and oily residue stay on these duct surfaces even after the fuel changed. Any sealant applied over that layer fails within a season.
- Shared systems circulating dust between apartments. In a multi-family building, one leaking joint doesn’t just lose air. It moves soot, renovation dust, and allergens from a stairwell or a neighbor’s apartment into yours, which is what turns a small gap into a tenant complaint.
The One Thing That Makes Fordham Ductwork Different
Here is the detail that changes the whole job in Fordham. The original galvanized ducts in these pre-war walk-ups were sized for gravity coal furnaces, then converted to forced-air oil or gas. That conversion didn’t just change the fuel; it changed the pressure. Many of those trunk runs were pinched, reduced, or routed through spaces where they were never meant to go, and a technician who only walks around looking for loose tape will miss it. You find the real problem with a camera, behind the walls. That’s why we inspect before we quote. In a building that’s been converted from coal to oil or gas, the failure is often in the middle of a run, not at the register.

See the difference
Before
After
Before
After
Before
AfterWhat a Typical Duct Repair Job in Fordham Looks Like
A common call in Fordham’s five- and six-story walk-ups starts with a tenant complaining about dust streaking from the registers after a renovation down the hall. A camera inspection often reveals a flex duct run crushed behind new drywall, or a trunk joint that pulled apart when the building was converted to gas heat. From there, the pro usually performs source removal under negative pressure with HEPA filtration, then seals the failed run with mastic or metal repair. The one thing they don’t do is cover it with tape, because tape won’t hold on soot-loaded galvanized steel. Before-and-after photos follow, which matters when a super or co-op board needs documentation that the work was actually done.
Pricing for Duct Repair & Sealing in Fordham, NY
These are typical ranges for Fordham. Every job gets a written estimate that sets the final price.
- Mastic sealing of accessible joints and trunk sections: typically $400 – $900 for an apartment system.
- Metal duct repair (rejoining a separated trunk, patching a hole): typically $350 – $800.
- Flex duct repair or rerouting behind drywall: typically $250 – $600 per run.
- Duct insulation on exposed or unconditioned runs: typically $300 – $700.
- Full-system sealing across a shared multi-family system: typically $1,200 – $3,000, depending on accessible length and how many units are involved.
What moves the number: how much of the duct is actually reachable, whether a run is behind finished drywall, and how much surface prep the steel needs before mastic goes on. We give you a written estimate per job, free, and before-and-after photos when we finish.
We Also Serve Cities Near Fordham
Our service area reaches beyond Fordham into Bedford Park, Tremont, Kingsbridge, and Spuyten Duyvil. The housing stock shifts a little block to block, but the same problems show up: older ductwork, converted heating systems, and sealant failures that were never properly fixed. If you’re nearby and your ducts are leaking or your registers are pushing dust, call and we’ll take a look.
Serving Fordham, NY – Our Local Coverage Area
We serve Fordham and nearby communities. Use the map below to see the area we cover. If you’re nearby, we can almost certainly help.
FAQs – Duct Repair & Sealing in Fordham
Because a board has to be able to show that the work was actually done and that the problem was addressed. In Fordham’s multi-family buildings, a duct seal job is often tied to a tenant complaint about dust or a failed inspection, so documentation matters. We photograph the failed joint or run before we touch it and again after sealing, so the building has a record it can hand to the board or a tenant.
In most cases, yes. We use a camera to find the actual failure point, then open only what we need to reach it. A lot of these runs are accessible from a ceiling hatch, a closet, or an existing utility chase, and there’s no reason to tear apart a whole apartment to seal one separated trunk joint. Where a run is boxed in with no access at all, we’ll tell you upfront and quote the access work separately. Call (844) 702-0856 for an exact quote; estimates are free.
The soot smell usually traces back to residual coal-era deposits on the duct walls and to separated trunk joints that pull that sooty air out of a wall cavity and back into the system. The original galvanized ducts here were sized and installed for coal furnaces, and the conversion to oil or gas didn’t clean the interior. If the joints are leaking, the smell comes through with the air. A cleaning plus sealing of the failed joints is the fix, and it’s usually the same visit.
It can help noticeably, because a sealed system doesn’t pull air in through gaps in the ductwork. A lot of the dust you see settling in a Fordham apartment comes in through leaking joints and return paths, not just open windows, especially on the lower floors near Fordham Road where bus and truck traffic loads the street air. Sealing the leaks reduces that path. We can also work with you on a Honeywell or Aprilaire filtration setup if you want to go further.
Because the duct surface wasn’t clean when it was applied. Galvanized steel in these pre-war buildings has accumulated soot and oily residue for decades, and mastic won’t bond to that. It looks fine at first, then lifts and flakes by the end of the heating season. We clean the surface, let it dry, then apply mastic. Ask us what equipment we’re bringing, and we’ll show you how we prep the steel on your system.
Call for a Free Duct Repair & Sealing Estimate in Fordham
If your registers are pushing dust, your top-floor heat is weak, or you can smell soot when the heat comes on, the ductwork is worth a look. Call (844) 702-0856 for a free estimate. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. One flat price per system gets agreed before work starts, the local pro is licensed and insured as New York requires, and you get before-and-after photos of your own ducts when it’s done.
Written by the team at Air Duct Cleaning Bedford Park.